What are the steps to create an automatic water dispenser in the Minecraft game

1, the core principle: This machine is mainly used in the launcher and the thrower, the launcher will be launched into the water or magma, can be directly salvaged

The thrower is responsible for the transmission of items, and combined with the game features of unlimited water, we can use it to carry out automatic water ~

2, automatic pump construction: After understanding the above knowledge points, how to use it? First let's dig out a 4x7x4 void

In the place marked by the normal square, stack four throwers, all facing upward, and place a box on top

As shown, two funnels are placed towards the thrower, and a transmitter is placed above the outer funnel

Then a funnel is placed above the launcher, next to it a thrower facing the funnel, and a funnel is placed above the thrower

Then, two ordinary squares are placed behind the transmitter, and the red stone comparator and the red stone repeater are placed on the ordinary square, and the repeater is sealed with the ordinary square

(Note the orientation of the repeater and comparator.)

Add a common square on the right, lay red stone powder and red stone repeater, and place a note box in front of the repeater

(Note box can be replaced with any opaque box.)

On the left, arrange the red stone powder and red stone repeater as shown in the picture, and place a red stone torch under the funnel below the transmitter, and put the red stone torch on the square marked in the picture

Next, the signal transmission device of the thrower pillar is made. On the other side of the thrower at the bottom, the red stone comparator, ordinary square, red stone powder and red stone torch are placed

This will allow the signal to pass two Spaces high, and then repeat this step above the same position so that the signal is enough to pass four Spaces high

The signal transmission device is complete - then next to the second height of the thrower, three ordinary squares are placed on the ordinary square with red stone powder and red stone repeater

The left and right sides of the funnel in front of the transmitter are filled with a common square, and a place for holding water is shown on one side, and two buckets of water are poured on the common square on both sides to form unlimited water

(None of these three compartments of water should be in a flowing state.)

Place six ordinary squares at the back of the box, and add a button in the upper right corner square, behind the corresponding square of the button, place a sticky piston and a red stone as a signal trigger device

Then a simple modification of the machine is done. When you need to pour water, you can put the container into the top funnel, and then press the button, you can wait for the water to be poured into the box